Energy Saving Tips
Switch off from the plug point
- Whenever we leave a plug point 'ON' after switching an electrical appliance 'OFF' with the remote, power is still being consumed in 'stand-by mode'. This accounts for an unbelievable 5% of power consumption.
- Utilise natural light as far as possible.
- Use lighter colours on the walls that reflect daylight.
- Allow daylight to penetrate the room by using light-coloured, loose-weave curtains.
- Switch off lights and fans when not required.
- Replace bulbs with tube lights & CFL (Compact Fluorescent Lamps).
- Use electronic chokes & regulators instead of conventional copper chokes.
- Optimise use of lights in malls, multiplexes & hotels.
- Turn off the lights when not in use.
- Turn off the lights when not in use.
- Clean all lighting fixtures periodically to maintain proper illumination.
- Use focused lighting - instead of brightly lighting an entire room, focus the light where it is needed.
- Select iron boxes with automatic temperature cutoff.
- Use appropriate regulator position for ironing.
- Do not put more water on clothes while ironing.
- Do not iron wet clothes.
- Replace conventional regulators with electronic regulators for ceiling fans.
- Install exhaust fans at a higher elevation than ceiling fans.
- Do not open door frequently.
- Set thermostat in medium cooling position.
- Keep adequate space from wall.
- Do not overload the refrigerator.
- Defrost your refrigerator regularly.
- Regularly defrost manual-defrost refrigerators and freezers; frost buildup increases the amount of energy
- needed to keep the motor running.
- Leave enough space between your refrigerator and the walls so that air can easily circulate around the refrigerator.
- Don't keep your refrigerator or freezer too cold.
- Make sure your refrigerator door seals are airtight.
- Cover liquids and wrap foods stored in the refrigerator. Uncovered foods release moisture and make the compressor work harder.
- Do not open the doors of the refrigerators frequently.
- Don't leave the fridge door open for longer than necessary, as cold air will escape.
- Use smaller cabinets for storing frequently used items.
- Avoid putting hot or warm food straight into the fridge.
- Use after 10 PM or before 10 AM.
- Run washing machine only with full load.
- Use the shortest cycle time.
- Use optimal quantity of water.
- Use timer facility to save energy.
- Use the correct amount of detergent.
- Use hot water only for very dirty clothes.
- Always use cold water in the rinse cycle.
- Prefer natural drying over electric dryers.
- Try to use before 10 AM.
- Switch off when not required
- Reduce thermostat setting from 60º to 50º C.
- Use Solar Water Heating System.
Kitchen Appliances Mixers
- Avoid dry grinding in your food processors (mixers and grinders) as it takes longer time than liquid grinding.
- Use these appliances to reduce energy consumption by 50 % compared to conventional electric / gas stoves.
- Do not bake large food items.
- Unless you're baking breads or pastries, you may not even need to preheat.
- Don't open the oven door too often to check food condition as each opening leads to a temperature drop of
- Turn off electric stoves several minutes before the specified cooking time.
- Use flat-bottomed pans that make full contact with the cooking coil.
- When cooking on a gas burner, use moderate flame settings to conserve LPG.
- Remember that a blue flame means your gas stove is operating efficiently.
- Yellowish flame is an indicator that the burner needs cleaning.
- Use pressure cookers as much as possible.
- Use lids to cover the pans while cooking.
- Bring items taken out of refrigerators (like vegetable, milk, etc.) to room temperature before placing on the gas stove for heating.
ACs are possibly the biggest cause of any summer power crisis. Every time one more AC is switched on and every time the temperature is lowered by one more degree, a huge load is added to the electrical system. We can however work towards uninterrupted power - if we give up 'freezing' for 'cool enough' - it's actually quite comfortable.
- Ensure proper sealing of doors and windows.
- Set thermostat at 24º C for optimum cooling.
- Clean AC filter every month.
- Use film / tinted glass on windows.
- Prefer air conditioners having automatic temperature cut off.
- Keep regulators at "low cool" position.
- Operate the ceiling fan in conjunction with your window air conditioner to spread the cooled air
- more effectively throughout the room.
- Seal the doors and windows properly.
- Leave enough space between your air conditioner and the walls to allow better air circulation.
- Use windows with sun films / curtains.
- Set your thermostat as high as comfortably possible in the summer. The less difference between the indoor
and outdoor temperatures,the lower will be energy consumption.
- Don't set your thermostat at a colder setting than normal when you turn on your air conditioner.
- It will not cool your home any faster and could result in excessive cooling
- Don't place lamps or TV sets near your air-conditioning thermostat. The thermostat senses heat from these
appliances, which can cause the air conditioner to run longer than necessary.
- Plant trees or shrubs to shade air-conditioning units but not to block the airflow.
- A unit operating in the shade uses as much as 10% less electricity than the same one operating in the sun.